:	May 24, 2004

.

Remove the brake booster.

.

Remove the headlamp switch.

.

Remove the driver side closing trim panel.   Release the clip.   Remove the 2 screws.   Disconnect the electrical connector.

.

Remove the instrument panel access panel.   Release the 2 clips.

.

Remove the brake pedal bracket.   Release the wiring harness clip.   Remove the 4 Torx bolts.

.

Release the stoplamp wiring harness.   Disconnect the electrical connector.   Release the 2 clips.

.

Remove the stoplamp switch.

.

Remove clutch pedal spring assister.

.

Release the clutch master cylinder.   Release the clutch master cylinder clevis pin.   Remove the 2 nuts.

.

Remove the pedal assembly.   Remove the 2 nuts.

.

:   Do not disassemble further if the component is removed for access only. Remove the brake pedal pad.

.

Remove the clutch pedal pad.

.

Remove the pedals.   Carefully release the spring tension.   Remove the bolt and discard the nut.

.

Remove the 3 pedal bushings.

.

Install the bushing.   Clean the component mating faces.   Lubricate the components.

.

Install the pedals.   Install the return spring.   Tighten the nut and bolt to 45 Nm (33 lb.ft).

.

Install the clutch pedal pad.

.

Install the brake pedal pad.

.

Install the stoplamp switch.

.

Install the pedal assembly.   Tighten the nuts to 25 Nm (18 lb.ft).

.

Install the clutch master cylinder.   Tighten the nuts to 10 Nm (7 lb.ft).   Install the clevis pin.

.

Install the clutch pedal spring assister.

.

Secure the wiring harness.   Secure the clips.   Connect the electrical connector.

.

Install the brake pedal bracket.   Tighten the Torx bolt to 10 Nm (7 lb.ft).   Secure the wiring harness.

.

Install the instrument panel access panel.   Secure with the clips.

.

Install the closing trim panel.   Connect the electrical connector.   Secure the clip.   Tighten the screws.

.

Install the headlamp switch.

.

Install the brake booster.